Installing a riser is similar to any routine septic tank maintenance procedure.
Septic tank riser installation.
Septic tank lids are usually buried 2 to 3 feet or more below the surface.
Install an adapter ring in the opening to the septic tank.
They sit on top of the tank and allow easy access for regular cleaning and pumping.
To install risers you must first gain access to the lid of the septic tank by digging down to it.
A riser will cost you about 300 to 400 installed very much worth it to give maintenance crew easy access should it needs repairs or maintenance.
Our septic tank risers include everything required for installation except the hand.
Next the riser replaces the lid to the access hole.
A pro shows you how to install a septic tank riser and new cover.
I wanted to show how easy it was to install the polyloc septic tank risers.
Expose enough space approximately 2 feet in all directions to allow room for the installer to move freely.
They will screw into place using the stainless steel screws.
Installing a septic tank riser will give you access to your septic tank at ground level by adding a piped shaft from the top of the tank to the ground level.
Bring your septic access up higher.
Jon haas has done this for years and demonstrates for y.
Add as many risers as you need to bring it up to the desired height.
In the past burying a septic tank lid 3 feet was the best way to ensure safety and security.
Septic tank risers are excellent additions to your septic tank.
Installing septic tank risers by tuf tite the right way.
Set the riser in place.
You have successfully installed a riser system on your septic tank that should pass inspection anywhere in the united states.
Now put your risers on your adapter ring.
If you do not know where your tank is located a septic tank technician can find the tank by probing the ground with a bar or using an electronic locating device.
Step 5 install an adapter ring.
The ground around the access hole is then dug up.
Remove the existing lid on the septic tank.